This instruction sheet may be translated into other languages. If you use procedures or service tools that are not recommended in this instruction sheet, YOU ALONE must decide if your actions might injure people or damage the outboard. Always wait for engine to cool down before performing work. Unless otherwise specified, engine must be OFF when performing this work.Īlways be aware of parts that can move, such as flywheels, propellers, etc. Use of substandard parts could result in injury or product malfunction.Īlways wear EYE PROTECTION AND APPROPRIATE GLOVES when using power tools. When replacement parts are required, use Evinrude/Johnson Genuine Parts or parts with equivalent characteristics, including type, strength and material. Should removal of any locking fastener (lock tabs, locknuts, or patch screws) be required, always replace with a new one. Torque wrench tightening specifications must strictly be adhered to.

Additional helpful information may be found in other service literature.ĭO NOT perform any work until you have read and understood these instructions completely.

This instruction sheet is not a substitute for work experience. Indicates an instruction which, if not followed, could severely damage engine components or other property.įor safety reasons, this kit must be installed by an authorized Evinrude®/Johnson® dealer. Indicates a hazardous situation which, if not avoided, could result in minor or moderate personal injury. Indicates a hazardous situation which, if not avoided, could result in death or serious injury. Indicates a hazardous situation which, if not avoided, will result in death or serious injury. The following symbols and/or signal words may be used in this document:

Evinrude nmea 2000 network furuno